What is the Suunto Tank POD? The Suunto Tank Pod is a wireless air pressure transmitter designed to enhance your diving experience by providing real-time tank pressure data to your dive computer. Like any electronic device, it requires periodic maintenance, including battery replacement. This guide ...

Apeks ID to AS568 O-Rings Standard for Apeks Regulators ProDive-shop recommends that your Apeks O-rings are installed by an authorized dealer or distributor! Do not damage the O-ring or the sealing surfaces! Make sure all parts are clean before assembling! First stages: US4, DS4, UST, ...

Why keep a dive logbook? (10 reasons)Safety Record: A logbook allows divers to keep track of important safety information, including dive times, depths, and any issues encountered during a dive. This information can be crucial for identifying patterns or potential problems.Dive Planning: By reviewin...

The Importance of Labeling Your Scuba Gear As a diver, keeping track of your gear is crucial for both safety and convenience. Losing or mixing up your equipment, such as a mask, fins, or regulator, can lead to unnecessary stress and potential hazards. This is where personalized sticker labels for di...

Mold, Rust, Black Dust, and Oil in Your Scuba Regulator: Are You Breathing Them In?How Does This Happen? Usage, Storage, and MaintenanceThe scuba regulator is the most crucial part of a diver's equipment, as it ensures a steady supply of breathable air underwater. Because of its importance, cleaning...

As a diver, your Suunto dive computer is an essential piece of equipment, providing vital information to ensure safe dives. To keep your device functioning optimally, you need to replace its battery periodically. Let's walk through the process of replacing the battery in your Suunto dive computer. ...

What battery does the Suunto D4i use? The Suunto D4, D4i and D4i Novo use a CR2450 3V lithium cell. A complete replacement also needs a fresh compartment O-ring and a thin film of silicone grease - fitting the cell on its own leaves the old seal in place and risks a flood. The Suunto D4i is a popu...

What battery does the Polar H10 use? The Polar H10 heart rate sensor uses a CR2025 3V coin cell. The cover on the back of the sensor pod turns anticlockwise with a coin or small flat tool, and the O-ring underneath it is what keeps the pod watertight - check that O-ring every time you change the ba...

Introduction A steady trickle of bubbles from your low-pressure (LP) inflator is almost always down to one tiny part: the O-ring inside the quick-disconnect coupling at the end of the hose. It is a cheap fix you can do yourself in a few minutes — the only fiddly bit is seating the new O-ring deep in...

Even if the dive gear is not used, once it is a few years old, all the o-rings will need replacing. The information that follows should help you to know more about the o-rings used in various scuba diving applicationO-Ring SizingAS568B as an Aerospace Standard that specifies sizes for O-rings used i...